EMC's Unique Features

• Easy to install weld-in end pieces only requires "squaring end to pipe"
• No requirement to "position" bolt holes, ends can be rotated to meet actual site requirements/one pass welding – no risk to seat or seal material as they are not present during welding
• Easy to install threaded ends, you can really torque the end connections, not usually possible unless valve is installed in sequence, without the associated twisting load on the body and risk of leaking
• Easy to position the center section as piping system may require
• Easy to "Re-position" valve as piping system is changed over time
• Pre-assembly in the workshop prior to final installation
• Installation instructions are simplified
• No stress on the valve due to piping stress - the RSA flanges allow the valve to take the “BEST” position